搜索资源列表
MotorKalman
- 步进电机的MATLAB仿真程序，采用了卡尔曼滤波，对定子电流进行估计，并估算出转子的位置和速度-Continuous time extended Kalman filter simulation for two-phase step motor，Estimate the stator currents, and the rotor position and velocity, on the basis of noisy measurements of the stator currents.
Sensorless_direct_torque_control_of_an_induction_m
- 感应电机的无传感器直接转矩控制技术（DTC）。控制电机的很好的方法-Induction motor sensorless direct torque control technology (DTC). Very good motor control method
sudheer
- DTC of indution motor using srtificaila intelligent techniques
DTC
- 异步电机的矢量控制，在matlab\sinmulink下调试通过-Induction motor vector control, in matlab \ sinmulink under the debugger through the
sensorless
- 关于永磁同步电机DTC系统的无速度传感器，效果还可以-On permanent magnet synchronous motor DTC system without a speed sensor, the effect can also be
MC
- matrix converter with induction motor
plane_dtc_load2332
- This is the simulink model for DTC of induction motor.
PV_System
- In this paper, new scheme of direct torque control of induction motor for electric vehicles is proposed and the results of an investigation into suitable torque control schemes are also presented. The electric vehicle drive consists of r
23825778dtc
- 异步电动机直接转矩控制基本原理及交流变频调速系统设计-Induction motor direct torque control and the basic principles of AC variable speed system design
DTC
- 三相异步电机的直接转矩控制matlab仿真模型，发出来供大家学习、指正，希望对你有用。-The simulink model of 3-phase iduction motor DTC control，it is maybe useful to your study.
dtc2levelind
- example of the dtc of the induction motor using 2 levels inverter
ac4_svm_dtc
- its about svpwm dtc of an induction motor drive
SVMDTC
- 本文件是处理永磁同步电机矢量直接转矩控制的程序，通过测试，性能很好的。-This document is handling direct torque permanent magnet synchronous motor vector control program, through testing, performance very good.
dtc
- 异步电机直接转矩控制（DTC）仿真电路图。 在MATLAB7.0以上的版本中都可以打开-DTC simulink model for motor
induction_motor_drive_flux_to_simulink_technology
- DTC simulation method of asynchronous motor in Matlab Simulink
matrixcon_im
- this is simulink file for matrix converter with induction motor
DTC
- Direct torque control of three phase induction motor which is most advanced ac drive technology .here matlab simulink model is developed for DTC induction motor-Direct torque control of three phase induction motor which is most advanced ac drive tec
819850674PMSM-DTC-Ccontrol
- direct torque control of permanent magnet motor
yibumotor_DTC_control
- 异步电机直接转矩控制系统仿真： 模型整体结构分为三大部分：主电路部分（直流电源、逆变器、电机）、控制系统部分（采用的是直接转矩控制，所以主要有坐标变换模块，灰色部分，磁链观测器模块，红色部分，直接转矩开关表选择模块，蓝色部分，以及外环的转速调节器ASR）剩下的就是仿真结果波形观测部分（观测信号依次向下为定子ab相线电压、三相定子电流、电机转速、电机电磁转矩） 运行初始条件为以1420r./min的额定转速电机空载启动，在0.3s时刻突加额定负载50牛米。在0.5s时刻电机转速突然下降为120
BLDC-DTC
- 这是关于无刷直流电机的DTC算法MATLAB验证。通过仿真效果很不错。(This is the MATLAB algorithm for the DTC algorithm of Brushless DC motor. The simulation results are very good.)